mass spectrometry comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-05-04. Where a claim depends on a specific study, the study is described rather than over-claimed.
Selank is a hydrophilic peptide and dissolves readily in water and in aqueous buffers. The lyophilised powder is typically a white to off-white solid. Because short peptides are prone to hydrolysis and oxidation, handling benefits from limiting exposure to heat, moisture and strong light. Working solutions are commonly prepared in sterile water or saline, and repeated freeze-thaw cycles are avoided to reduce aggregation and loss of activity. These practices reflect general laboratory convention rather than published stability specifications.
Dry powder is normally held at -20 degrees Celsius or lower, in a sealed container with desiccant and protection from light. Reconstituted solutions are usually kept at 2 to 8 degrees Celsius for short periods and frozen for longer ones. Proline residues at several positions are generally associated with some resistance to peptidase attack, but chemical stability still declines at neutral to alkaline pH and at elevated temperature. Exact shelf-life figures are product-specific and are not standardised across suppliers.
Characterization of Selank in a laboratory setting relies on standard peptide methods. Reverse-phase high-performance liquid chromatography separates the target from related impurities and provides a purity figure, commonly reported as 95 percent or higher. Mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, confirms the molecular mass and helps detect truncation or modification. Amino acid analysis can verify composition when a sequence-level check is needed. These techniques together establish identity and purity for a given lot.
Lyophilized Selank, the dry powder form, is generally stored frozen at minus 20 degrees Celsius or colder for long-term keeping. The solid is hygroscopic and should stay sealed, dry, and protected from light. Once dissolved, the peptide is less stable and is usually held refrigerated at 2 to 8 degrees Celsius for short periods. Repeated freezing and thawing is avoided because it can promote aggregation and loss of activity. Buffers and pH choice also affect how long a solution remains usable.
Solubility behavior is a practical concern for handling. Selank dissolves readily in water and in common aqueous buffers, which simplifies preparation of working solutions. The choice of solvent, ionic strength, and pH can influence aggregation over time, particularly at higher concentrations. Aqueous solutions are typically sterile-filtered before use. Because stability depends on several variables, storage and handling notes should be treated as general guidance rather than fixed rules, and specific values are best confirmed against a certificate of analysis for each batch.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised solid form |
| Solubility class | Freely soluble in water | Hydrophilic heptapeptide |
| Dry storage temperature | -20 degrees Celsius or lower | Sealed, desiccated, protected from light |
| Solution storage | 2 to 8 degrees Celsius short term | Avoid repeated freeze-thaw cycles |
| Common identification method | Reversed-phase HPLC with mass spectrometry | Confirms purity and molecular mass |
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, frequently abbreviated as TKPRPGP. It was designed as a structural analogue of tuftsin, a naturally occurring tetrapeptide released by enzymatic cleavage of the immunoglobulin heavy chain. The two additional proline residues at the C-terminal end extend the parent chain and change how the molecule behaves in solution. The free peptide has a calculated molecular mass of approximately 751.9 g/mol and is generally supplied as a lyophilised white to off-white powder.
Development work on the compound began in the 1980s and 1990s at the Institute of Molecular Genetics in Moscow, within the same research programme that produced the peptide Semax. Early investigators sought a tuftsin derivative with improved resistance to enzymatic breakdown and with activity in the central nervous system after peripheral administration. Most of the primary literature from this period was published in Russian, a factor that still shapes how easily the findings can be checked by outside groups.
The compound was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences during the 1980s and 1990s. The stated design goal was to retain the immunomodulatory and central nervous system activity attributed to tuftsin while improving resistance to enzymatic breakdown. Adding a proline-rich tail to the short parent peptide was a deliberate strategy, because proline residues restrict the conformations available to many peptidases. The same laboratory produced Semax, an ACTH fragment analog, and both compounds were developed in parallel as short, enzymatically stabilized peptides intended for intranasal use.
Selank is not a naturally occurring peptide and has no known endogenous counterpart in human physiology. Russian-language sources frequently call it TP-7, while English-language sources use the name Selank almost exclusively. Database indexing is uneven, partly because early reports appeared in regional journals that are not widely cataloged. Some summaries describe the material as a tuftsin analog and others as a synthetic heptapeptide; the labels overlap rather than conflict. Citing the primary sequence resolves ambiguity more reliably than the research or trade name alone.
Selank is a synthetic heptapeptide developed in Russia as a structural analogue of tuftsin, a naturally occurring immunomodulatory tetrapeptide. Its sequence, Thr-Lys-Pro-Arg-Pro-Gly-Pro, keeps the tuftsin core at the N-terminus and appends a Pro-Gly-Pro tail. Researchers at the Institute of Molecular Genetics in Moscow synthesized the compound during the 1990s while searching for peptides with combined anxiolytic and immunomodulatory activity. The added tail was intended to resist enzymatic cleavage and prolong the molecule's presence in circulation.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Regulatory status differs sharply by region. Selank holds a Russian marketing authorization, where it is supplied mainly as nasal drops, while authorities elsewhere have not approved it for medical use. Material sold internationally is therefore usually labeled as a research chemical rather than a medicine. Peer-reviewed publications come predominantly from Russian laboratories, and sample sizes are generally small. Whether the compound produces comparable effects under independent, well-controlled replication remains an open question that the broader literature has not settled.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
In November 2022, it was announced that McDonald's was leaving Belarus on 22 November and that the Russian fast food chain Vkusno i tochka would take its place. However, this did not happen, and the operations of McDonald's was extended until 27 November; since then, the restaurants operated under the sign "We are open!" (Russian: Мы открыты!, IPA: [ˌmɨ ɐtˈkrɨtɨ]). In early April 2023, KSB Victory Restaurants (Russian: КСБ Виктори Рестораны, IPA: [ˌkaɛzˈbɛ vʲɪkˈtorʲɪ rʲɪstɐˈranɨ]), operators of McDonald's in the country, filed an application for registration of the name and trademark "Mak.by". On April 18, 2023, the restaurant chain was renamed Mak.by.
== Structure and active site == Apamin is a polypeptide possessing an amino acid sequence of H-Cys-Asn-Cys-Lys-Ala-Pro-Glu-Thr-Ala-Leu-Cys-Ala-Arg-Arg-Cys-Gln-Gln-His-NH2 (one-letter sequence CNCKAPETALCARRCQQH-NH2, with disulfide bonds between Cys1-Cys11 and Cys3-Cys15). Apamin is very rigid because of the two disulfide bridges and seven hydrogen bonds. The three-dimensional structure of apamin has been studied with several spectroscopical techniques: HNMR, Circular Dichroism, Raman spectroscopy, FT-IR. The structure is presumed to consist of an alpha-helix and beta-turns, but the exact structure is still unknown. By local alterations it is possible to find the amino acids that are involved in toxicity of apamin. It was found by Vincent et al. that guanidination of the ε-amino group of lysine4 does not decrease toxicity. When the ε-amino group of lysine4 and the α-amino group of cysteine1 are acetylated or treated with fluorescamine, toxicity decreases with a factor of respectively 2.5 and 2.8. This is only a small decrease, which indicates that neither the ε-amino group of lysine4 nor the α-amino group of cysteine1 is essential for the toxicity of apamin. Glutamine7 was altered by formation of an amide bond with glycine ethyl ester, this resulted in a decrease in toxicity of a factor 2.0. Glutamine7 also doesn't appear to be essential for toxicity. When histidine18 is altered by carbethoxylation, toxicity decreases only by a factor 2.6.
=== Constitutive activity === One important feature of GHS-R1a is that there is still some activity in the receptor even when it is not actively being stimulated. This is called constitutive activity, and it means that the receptor is always "on," unless acted on by an inverse agonist. This constitutive activity seems to provide a tonic signal required for the development of normal height, probably through an effect on the GH axis. In fact, some GHS-R1a genetic variations, caused by single nucleotide polymorphisms (SNPs), have been found to be associated with hereditary obesity and others with hereditary short stature. It was also found that, when GHS-R1A constitutive activity was diminished, there were decreased levels of hunger-inducing hormone neuropeptide Y (NPY) as well as in food intake and body weight.
Sources: en.wikipedia.org
During the warm months of June, July, and August, typical high temperatures are 20 to 26 °C (68 to 79 °F). However, during heat waves (which can occur between May and September), daytime high temperatures often exceed 30 °C (86 °F), sometimes for a week or two. In the winter, average temperatures normally fall to approximately −10 °C (14 °F). Nevertheless, most winters have warmer periods with daytime temperatures rising above 0 °C (32 °F), as well as cooler periods with night temperatures falling below −20 °C (−4 °F). These periods usually last a week or two. The growing season in Moscow normally lasts for 156 days, usually around 1 May to 5 October. The highest temperature ever recorded in Moscow was 38.2 °C (100.8 °F) at the VVC weather station, as well as 39.0 °C (102.2 °F) in the center of Moscow and at Domodedovo airport; this temperature occurred on 29 July 2010, during the unusual 2010 Northern Hemisphere heat waves. Record high and average temperatures were recorded in January, March, April, May, June, July, August, November, and December of 2007–2022. The average July temperature from 1991 to 2020 is 19.7 °C (67.5 °F). The lowest temperature ever recorded was −42.1 °C (−43.8 °F) in January 1940. Snow, which is present for about five months a year, often begins to fall in mid-October; snow cover persists in late November and melts at the end of March. On average, Moscow receives 1731 hours of sunshine per year, ranging between 8% in December and 52% from May to August. This annual variation is due to convective cloud formation.
=== Full division === Archosaurs (crocodilians and birds) and mammals show complete separation of the heart into two pumps for a total of four heart chambers; it is thought that the four-chambered heart of archosaurs evolved independently from that of mammals. In crocodilians, there is a small opening, the foramen of Panizza, at the base of the arterial trunks and there is some degree of mixing between the blood in each side of the heart, during a dive underwater; thus, only in birds and mammals are the two streams of blood—those to the pulmonary and systemic circulations—permanently kept entirely separate by a physical barrier.
== History == Although many authors had suggested the use of power formulas in sediment transport in the decades preceding Bagnold's work, and in fact Bagnold himself suggested it a decade before putting it into practice in one of his other works, it wasn't until 1966 that R. A. Bagnold tested this theory experimentally to validate whether it would indeed work or not. This was successful and since then, many variations and applications of stream power have surfaced. The lack of fixed guidelines on how to define stream power in this early stage lead to many authors publishing work under the name "stream power" while not always measuring the entity in the same way; this led to partially failed efforts to establish naming conventions for the various forms of the formula by Rhoads two decades later in 1986. Today stream power is still used and new ways of applying it are still being discovered and researched, with a large integration into modern numerical models utilizing computer simulations.
Sources: en.wikipedia.org
Dry powder is normally held at -20 degrees Celsius or below in a sealed, light-protected container with desiccant. Brief room-temperature handling during weighing is generally tolerated. Storage instructions vary between suppliers, so the accompanying certificate of analysis should be followed.
Reversed-phase HPLC establishes purity, while mass spectrometry confirms the expected molecular mass. Sequence confirmation may use tandem mass spectrometry or peptide mapping. A certificate of analysis typically reports these results alongside the analytical method applied.
In Russia it is a registered medicine available by prescription. In many other countries it is not approved for human use and is supplied only as a research chemical. Import and possession rules differ by jurisdiction, and buyers are responsible for checking local requirements.
Reverse-phase HPLC is the usual method and gives a percentage purity value. Mass spectrometry then confirms the molecular mass. Together they provide a basic identity and purity profile for a lot.