The short version of GABA-A modulation fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-08-08 and is reviewed periodically as new material appears.
Laboratory work relies on standard behavioral paradigms. Rodents are tested in the elevated plus maze, open field, and passive avoidance tasks, with outcomes compared against diazepam or vehicle controls. Intranasal dosing is used most often because it bypasses first-pass metabolism, though intraperitoneal and intravenous routes also appear in published protocols. Biochemical endpoints include tissue BDNF concentrations, cytokine levels, and monoamine metabolites. Human data are limited to small Russian trials reporting reduced anxiety scores; most were not prospectively registered, and few employed independent outcome assessment.
Measuring peptide exposure inside the brain is technically difficult. Selank is degraded rapidly in plasma, and assays must separate intact peptide from fragments, which favors targeted mass spectrometry over immunoassays alone. Reported half-lives are short, on the order of minutes, so effects observed hours later are attributed to downstream signaling rather than to the parent compound. Blood-brain barrier permeability is debated and rarely quantified directly. Gaps include absent dose-response characterization, inconsistent reporting of purity, and almost no pharmacokinetic data from human participants.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
| Property | Value | Notes |
|---|---|---|
| Principal proposed target | GABA-A receptor complex | Hypothesis derived mainly from animal pharmacology |
| Common behavioral assay | Elevated plus maze | Rodent test for anxiety-like behavior |
| Reported molecular marker | Hippocampal BDNF expression | Measured by immunoassay or mRNA quantification |
| Typical dosing route | Intranasal | Chosen to reduce first-pass metabolism |
| Reported plasma half-life | Minutes | Based on limited peptide stability data |
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter notation. Its structure consists of the immunomodulatory tetrapeptide tuftsin, Thr-Lys-Pro-Arg, extended at the carboxyl terminus by a Pro-Gly-Pro segment. The molecular formula is commonly given as C33H57N11O9, corresponding to a monoisotopic mass near 751.4 Da and an average molecular mass near 751.9 Da. All seven residues are proteinogenic amino acids, and the molecule carries no modified side chains or non-natural linkages.
The compound was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences during the 1980s and 1990s. The stated design goal was to retain the immunomodulatory and central nervous system activity attributed to tuftsin while improving resistance to enzymatic breakdown. Adding a proline-rich tail to the short parent peptide was a deliberate strategy, because proline residues restrict the conformations available to many peptidases. The same laboratory produced Semax, an ACTH fragment analog, and both compounds were developed in parallel as short, enzymatically stabilized peptides intended for intranasal use.
Selank is not a naturally occurring peptide and has no known endogenous counterpart in human physiology. Russian-language sources frequently call it TP-7, while English-language sources use the name Selank almost exclusively. Database indexing is uneven, partly because early reports appeared in regional journals that are not widely cataloged. Some summaries describe the material as a tuftsin analog and others as a synthetic heptapeptide; the labels overlap rather than conflict. Citing the primary sequence resolves ambiguity more reliably than the research or trade name alone.
Proposed mechanisms center on modulation of the GABA system, but no single molecular target has been confirmed. Rodent studies report changes in GABA-A receptor expression and in the turnover of serotonin, dopamine, and norepinephrine in several brain regions. Increases in brain-derived neurotrophic factor and its receptor have also been described after repeated administration. These findings come largely from animal models, and the degree to which they describe human neurochemistry remains an open question. The mechanism is best characterized as multi-system and not fully resolved.
Pharmacokinetic data are limited. Like most short peptides, Selank is vulnerable to plasma and tissue peptidases, and its measured half-life in circulation is short, on a minutes scale. The Pro-Gly-Pro tail slows this degradation but does not eliminate it. Intranasal administration is the route described in most reports, with absorption through the nasal mucosa and a hypothesized path into the central nervous system that avoids the blood-brain barrier. Direct measurements of human brain exposure are unavailable, so distribution claims rest on inference from animal work.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
=== Protein purification === When purifying protein from a biological extract, streptomycin sulfate is sometimes added as a means of removing nucleic acids and ribonuclear proteins. Since it binds to ribosomes and precipitates out of solution, it serves as a method for removing rRNA, mRNA, and even DNA if the extract is from a prokaryote.
The first report of the discovery of element 105 came from the Joint Institute for Nuclear Research (JINR) in Dubna, Moscow Oblast, Soviet Union, in April 1968. The scientists bombarded 243Am with a beam of 22Ne ions, and reported 9.4 MeV (with a half-life of 0.1–3 seconds) and 9.7 MeV (t1/2 > 0.05 s) alpha activities followed by alpha activities similar to those of either 256103 or 257103. Based on prior theoretical predictions, the two activity lines were assigned to 261105 and 260105, respectively.
== Evolution == Serpins are the most widely distributed and largest superfamily of protease inhibitors. They were initially believed to be restricted to eukaryote organisms, but have since been found in bacteria, archaea and some viruses. It remains unclear whether prokaryote genes are the descendants of an ancestral prokaryotic serpin or the product of horizontal gene transfer from eukaryotes. Most intracellular serpins belong to a single phylogenetic clade, whether they come from plants or animals, indicating that the intracellular and extracellular serpins may have diverged before the plants and animals. Exceptions include the intracellular heat shock serpin HSP47, which is a chaperone essential for proper folding of collagen, and cycles between the cis-Golgi and the endoplasmic reticulum. Protease-inhibition is thought to be the ancestral function, with non-inhibitory members the results of evolutionary neofunctionalisation of the structure. The S to R conformational change has also been adapted by some binding serpins to regulate affinity for their targets.
Sources: en.wikipedia.org
By choosing porous graphitic carbon as a stationary phase for liquid chromatography, even non derivatized glycans can be analyzed. Electrospray ionisation (ESI) is frequently used for this application.
The chemical model will include values of the protonation constants of the ligand, which will have been determined in separate experiments, a value for log Kw and estimates of the unknown stability constants of the complexes formed. These estimates are necessary because the calculation uses a non-linear least-squares algorithm. The estimates are usually obtained by reference to a chemically similar system. The stability constant databases can be very useful in finding published stability constant values for related complexes. In some simple cases the calculations can be done in a spreadsheet. Otherwise, the calculations are performed with the aid of a general-purpose computer programs. The most frequently used programs are:
=== Biomaterials === Biomaterial surfaces are often modified using light-activated mechanisms (such as photografting) to functionalize the surface without compromising bulk mechanical properties. The modification of surfaces to keep polymers biologically inert has found wide uses in biomedical applications such as cardiovascular stents and in many skeletal prostheses. Functionalizing polymer surfaces can inhibit protein adsorption, which may otherwise initiate cellular interrogation upon the implant, a predominant failure mode of medical prostheses.
Sources: en.wikipedia.org
Intranasal administration predominates in both animal and human research because it avoids hepatic first-pass metabolism. Injectable and intraperitoneal routes appear in animal work mainly for comparison.
Behavioral endpoints include time spent in open arms of the elevated plus maze and avoidance latencies. Biochemical endpoints include BDNF concentration, cytokine levels, and monoamine metabolite ratios in brain tissue.
Most published studies are small, originate from a limited number of laboratories, and lack independent replication. Dose-response relationships, measured brain exposure, and long-term outcomes are not well characterized.
Purity is usually reported as an HPLC area percentage, most often measured at 214 nm. Identity is confirmed separately by mass spectrometry. A certificate of analysis should state both the method and the observed value.