Everything below concerns reverse-phase HPLC. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-04-12. Numbers and descriptions here follow the published literature rather than marketing material.
Peptide bonds are vulnerable to protease attack, and Selank is no exception. Measured half-life in serum is short, on the order of minutes in several reports, which explains why intranasal administration is the common route described in the literature. Absorption across the nasal mucosa partially bypasses first-pass hepatic metabolism. Quantitative data on human bioavailability remain limited and are difficult to compare across studies.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
| Property | Value | Notes |
|---|---|---|
| Dry storage temperature | -20 C or below | Sealed, desiccated, protected from light |
| Solution stability | Hours to days at 2-8 C | Depends on buffer and microbial load |
| Preferred pH range | Near neutral to slightly acidic | Alkaline pH accelerates hydrolysis |
| Main degradation routes | Hydrolysis and deamidation | No cysteine or methionine in sequence |
| Identity confirmation | Electrospray mass spectrometry | Observed mass compared with 751.9 Da |
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Regulatory status differs sharply by region. Selank holds a Russian marketing authorization, where it is supplied mainly as nasal drops, while authorities elsewhere have not approved it for medical use. Material sold internationally is therefore usually labeled as a research chemical rather than a medicine. Peer-reviewed publications come predominantly from Russian laboratories, and sample sizes are generally small. Whether the compound produces comparable effects under independent, well-controlled replication remains an open question that the broader literature has not settled.
Proposed mechanisms centre on the GABAergic system. Animal and tissue studies report changes in GABA-A receptor expression and reduced activity of GABA transaminase, the enzyme that degrades GABA. Effects on monoamine turnover, including serotonin and dopamine pathways, are also described, and a separate line of work links the peptide to increased expression of brain-derived neurotrophic factor in hippocampal tissue. Most of these findings come from rodent models and cell preparations. How the individual observations combine into a single coherent mode of action is not settled.
Pharmacokinetic data are sparse and largely derived from animal work. After intranasal administration the peptide appears in plasma within minutes, and reported half-lives are short, on the order of minutes to tens of minutes. Degradation proceeds through ordinary proteolytic cleavage into constituent amino acids and smaller fragments. Direct evidence that intact Selank reaches brain tissue in meaningful amounts is limited, and the extent of blood-brain barrier penetration is debated. Some authors argue that fragments, not the parent peptide, carry much of the observed activity.
Characterization of Selank in a laboratory setting relies on standard peptide methods. Reverse-phase high-performance liquid chromatography separates the target from related impurities and provides a purity figure, commonly reported as 95 percent or higher. Mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, confirms the molecular mass and helps detect truncation or modification. Amino acid analysis can verify composition when a sequence-level check is needed. These techniques together establish identity and purity for a given lot.
Lyophilized Selank, the dry powder form, is generally stored frozen at minus 20 degrees Celsius or colder for long-term keeping. The solid is hygroscopic and should stay sealed, dry, and protected from light. Once dissolved, the peptide is less stable and is usually held refrigerated at 2 to 8 degrees Celsius for short periods. Repeated freezing and thawing is avoided because it can promote aggregation and loss of activity. Buffers and pH choice also affect how long a solution remains usable.
Solubility behavior is a practical concern for handling. Selank dissolves readily in water and in common aqueous buffers, which simplifies preparation of working solutions. The choice of solvent, ionic strength, and pH can influence aggregation over time, particularly at higher concentrations. Aqueous solutions are typically sterile-filtered before use. Because stability depends on several variables, storage and handling notes should be treated as general guidance rather than fixed rules, and specific values are best confirmed against a certificate of analysis for each batch.
=== List of side effects === Cardiovascular: Myocardial infarction; stroke; heart block; arrhythmias; hypotension, particularly orthostatic hypotension; hypertension; tachycardia; palpitation. Psychiatric: Confusional states (especially in the elderly) with hallucinations, disorientation, delusions, anxiety, restlessness, agitation; hypomania; exacerbation of psychosis; insomnia, panic, and nightmares. Neurological: Seizures; incoordination; ataxia; tremors; peripheral neuropathy; numbness, tingling, and paresthesias of extremities; extrapyramidal symptoms; drowsiness; dizziness; weakness and fatigue; headache; syndrome of inappropriate ADH (antidiuretic hormone) secretion; tinnitus; alteration in EEG patterns. Anticholinergic: Paralytic ileus; hyperpyrexia; urinary retention, delayed micturition, dilatation of the urinary tract; constipation; blurred vision, disturbance of accommodation, increased intraocular pressure, mydriasis; dry mouth and rarely associated sublingual adentitis. Allergic: Drug fever; petechiae, skin rash, urticaria, itching, photosensitization (avoid excessive exposure to sunlight); edema (general, or of face and tongue). Hematologic: Agranulocytosis; bone marrow depression; leukopenia;thrombocytopenia; purpura; eosinophilia. Gastrointestinal: Nausea and vomiting; anorexia; epigastric distress; diarrhea; peculiar taste; stomatitis; abdominal cramps; black tongue.
Recent advances have enabled simultaneous profiling of chromatin accessibility alongside other molecular modalities in the same cells or tissue sections. Spatial ATAC–RNA-seq and spatial CUT&Tag–RNA-seq allow co-profiling of genome-wide chromatin accessibility or histone modifications in conjunction with whole transcriptome on the same tissue section at near-single-cell resolution. ISSAAC-seq (In Situ Sequencing of chromatin Accessibility And Cellular transcriptomes) represents a multimodal update to ATAC-seq, providing a powerful method for investigating gene expression and chromatin accessibility within the same cell at high sensitivity and lower cost than commercially available kits. These multimodal approaches have led to the development of computational tools like SCRIPro, which combines transcription factor-target importance from epigenomic data with transcription factor-target expression from transcriptomic data to construct gene regulatory networks from single-cell and spatial multiomics data.
The ENCODE project proposes to map all of the DHSs in the human genome with the intention of cataloging human regulatory DNA. DHSs mark transcriptionally active regions of the genome, where there will be cellular selectivity. So, they used 125 different human cell types. This way, using the massive sequencing technique, they obtained the DHSs profiles of every cellular type. Through an analysis of the data, they identified almost 2.9 million distinct DHSs. 34% were specific to each cell type, and only a small minority (3,692) were detected in all cell types. Also, it was confirmed that only 5% of DHSs were found in TSS (Transcriptional Start Site) regions. The remaining 95% represented distal DHSs, divided in a uniform way between intronic and intergenic regions. The data gives an idea of the great complexity regulating the genetic expression in the human genome and the quantity of elements that control this regulation. The high-resolution mapping of DHSs in the model plant Arabidopsis thaliana has been reported. Total 38,290 and 41,193 DHSs in leaf and flower tissues have been identified, respectively.
The assay has a very good sensitivity (detection limit for 17β-estradiol in the YES assay about 5 × 10−12 M or 1.4 ng/L), and the microplate format requires only small amounts of sample. Analysis of native aqueous samples, concentrated environmental samples and chemicals or mixtures in solvents like ethanol or DMSO is possible. Results can be obtained as quickly as after an overnight exposure. The handling of yeast cells is generally less demanding than mammalian cell culture. No international standards are available to date. An ISO guideline for the YES assay is under preparation. Saliva hormone testing
==== Original attempt – Gorin ==== In 1974, French film-maker Jean-Pierre Gorin commissioned Dick to write a screenplay based on Ubik. Dick completed the screenplay within a month, but Gorin never filmed it. The screenplay was published as Ubik: The Screenplay in 1985 (ISBN 978-0911169065) and again in 2008 (ISBN 9781596061699). Dick's former wife Tessa claims that the published screenplay "has been heavily edited, and others have added material to the screenplay that Phil wrote", though she suggests that "film producers really ought to take a look at the author's own screenplay before embarking upon their journey of interpretation".
Sources: en.wikipedia.org
==== Canada ==== In October 2018, cannabidiol became legal for recreational and medical use by the federal Cannabis Act. As of August 2019, CBD products in Canada could only be sold by authorized retailers or federally licensed medical companies, limiting their access to the general public. Nonetheless, with online delivery services and over 2,600 authorized cannabis retail stores as of October 2021, accessibility has steadily increased over time. The Canadian government states that CBD products "are subject to all of the rules and requirements that apply to cannabis under the Cannabis Act and its regulations." It requires "a processing licence to manufacture products containing CBD for sale, no matter what the source of the CBD is, and that CBD and products containing CBD, such as cannabis oil, may only be sold by an authorized retailer or licensed seller of medical CBD." Edible CBD products were scheduled to be permitted for sale in Canada on October 17, 2019, for human consumption. As of August 2020, it was still illegal to carry cannabis and cannabis-derived products (including products containing CBD) across the Canadian border. If one carries any amount of cannabis for any purpose (including medical), it needs to be declared to the Canada Border Services Agency. Not declaring it is a serious criminal offence.
=== Contact lenses === The early stages of pellucid marginal degeneration may also be managed with soft contact lenses. Success has been shown with the use of rigid gas permeable contact lenses combined with over-refraction. People wearing contacts don't report increased problems with glare and contrast sensitivity, but it is not clear if this is due to the corneal disease, or the contact lenses themselves. New studies found that the use of scleral contact lens, a type of rigid gas permeable (RGP) lens, may be a good option for most people with PMD. Most of these lenses are in the range of 15.5mm to 18.0mm in diameter. Regardless of the lens size, it is thought that the larger the RGP lens will in most cases be more comfortable than standard rigid corneal lenses, and at times more comfortable than soft lenses, regardless of the fact that it is a rigid lens. The highlight to the scleral design and the correction of eye disorders such as pellucid marginal degeneration is that vision with these types of lenses is exceptional when fit correctly.
Chemist James Young in 1847 noticed a natural petroleum seepage in the coal mine at Riddings, Derbyshire, from which he distilled a light thin oil suitable for use as lamp oil, at the same time obtaining a more viscous oil suitable for lubricating machinery. In 1848, Young set up a small business refining crude oil. Young eventually succeeded (by distilling cannel coal at low heat) in creating a fluid resembling petroleum, which when treated in the same way as the seep oil gave similar products. Young found that by slow distillation he could obtain several useful liquids from it, one of which he named "paraffine oil" because at low temperatures it congealed into a substance resembling paraffin wax. The production of these oils and solid paraffin wax from coal formed the subject of his patent dated October 17, 1850. In 1850, Young & Meldrum and Edward William Binney entered into partnership under the title of E.W. Binney & Co. at Bathgate in West Lothian and E. Meldrum & Co. at Glasgow; their works at Bathgate were completed in 1851 and became the first truly commercial oil-works in the world with the first modern oil refinery. The demand for petroleum as a fuel for lighting in North America and around the world quickly grew. The first oil well in the Americas was drilled in 1859 by Edwin Drake at what is now called the Drake Well in Cherrytree Township, Pennsylvania. There also was a company associated with it, and it sparked an oil boom and rapid expansion of the global petroleum industry. The same year, engine-drilled wells appeared in West Virginia.
Like eukaryotic protein kinases (ePKs) the different isoforms of the CK1 family consist of a N-terminal and a C-terminal lobe (N- and C-lobe, respectively), which are connected via a hinge region. While the N-lobe is mainly composed by β-sheet strands, the larger C-lobe predominantly consists of α-helical and loop structures. Between both lobes a catalytic cleft is formed, accommodating substrates and ATP for the kinase reaction.
Sources: en.wikipedia.org
Dry powder is best kept sealed, protected from light, and held at minus 20 degrees Celsius or below. Desiccant packaging helps limit moisture uptake because the material is hygroscopic. A sealed vial should be allowed to equilibrate to room temperature before opening to reduce condensation.
Hydrolysis of peptide bonds and deamidation of arginine and proline residues are the main degradation routes. Alkaline pH and higher temperatures accelerate both processes. Buffered, near-neutral solutions stored cold generally degrade more slowly than unbuffered ones.
Reverse-phase chromatography gives the clearest single view of related impurities and truncated sequences. Mass spectrometry then confirms that the main peak carries the expected mass. Neither test detects enantiomeric impurities, which require a separate chiral assay.
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.